Hurricane 5449 Wastegate Kit
WG arm length: 88mmThread length: 40mm Clevis length: 65mmAdjustable length: ~120-145mmStroke: 20mmOpening pressure: ~0,7bar / 10PSIFully open pressure: ~2,4bar / 35PSIMounting bolt CC: 35mmMounting bolt hole: 6mm Assembly instructions:Mount the wastegate on the turbo unit and adjust it so there is at least a 2mm bias.
-
Beskrivning
WG arm length: 88mm
Thread length: 40mm
Clevis length: 65mm
Adjustable length: ~120-145mm
Stroke: 20mm
Opening pressure: ~0,7bar / 10PSI
Fully open pressure: ~2,4bar / 35PSI
Mounting bolt CC: 35mm
Mounting bolt hole: 6mmAssembly instructions:
Mount the wastegate on the turbo unit and adjust it so there is at least a 2mm bias.
Using a pressure gauge: Check when the wastegate arm starts to open.Adjust the wastegate with more pre-tension (3mm+) if you want a higher opening pressure.
Adjust until you get the desired opening pressure.Note that measured opening pressure may vary during use due to exhaust pulses, exhaust pressure, back pressure and heat.
-
Fråga om produkt
Du får snabbast svar genom informationen i våra guider. Vi uppdaterar dem ständigt för att du skall få snabbast och bästa support.
-
Recensioner
Bli först med att recensera denna produkt!
Din recension:
För att skicka en recension måste du vara inloggad.
-
Om tillverkaren
----------------
Guider & Info